![]() Some time you will get slower bandwidth than using 20MHz (I think it because the conflicted with other WiFi).Īnd maybe I wrong but as I know, when you want a good signal of wifi, you need:ġ/ The noise of other wifi is slow (from -60 to -99).Ģ/ And the good signal of your wifi (from -20 to -50). And the real bandwidth when test with speedtest and download from server is not over 30Mbps on my iPhone. The bandwidth show in Winbox tool are: my laptop is 300 Mbps/300Mbps, but my iPhone is still 65Mbps/65Mbps. I have tried 20/40 mode before, but the result isn't good. I don't use iThings at all, but they are widely discussed as not always fully following the wifi standards. Also take care not to have too strong signal (minus50-60db) and to have good signal to noise ratio (at least 40db). Use spectral scan in addition, you can see things. But by anyway, I love the funtions of winbox, I can know exactly what happen in the router.ĭon't rely on ssider only. PS: This's the first time I meet a device what I can vote it's good or bad. If someone know anything else, please tell me know. Or this is a bug of software made anys have "power save" wireless option can't over 65Mbps/20/1S. ![]() So in the end, I guess hAP using inner-anten so the Tx signal's not good enough when send data mobile devices (I test with an other Kindle HD too). I have checked againt with a longer time and see something fun:ġ/ My laptop's Tx/Rx rate will drop to 65Mbps too (Winbox show 65Mbps 20/1S), it's happen randomly, even when I sit next to the router hAP.Ģ/ My Iphone's have support HT20-7 in signal tab, and I remember with this I have got a real down/up rate over 45Mbps on other router.ģ/ The max rate of mobile devices is 65Mbps-20MHz/1S (not 72Mbps on the 1st post, very sorry about this mistake). I'm using an RouterOS v6.29.1 with all lasted packages too. I don't see wireless-fp option on my router, and after a little search I think it's wireless-cm2, is it right? If that's it, I have this packet is enabled. I have used the options like you said but it's result is worse than 20MHz (I think it's because noise of others wifi). Try to setup a 20/40Mhz channel, set the rts/cts, distance to indoor, enable the Wireless-fp package. Because I have research before test, and tried come far and near the router.ĭoes anyone know something? Please help me. I don't think this is because noise or distance. I don't know why!? I have test many wireless router with this option, I've only get the same bad or good result on both my laptop and my iphone before. I check in info tab of registried device and see my iphone can't get over 75Mbps/75Mbps when my laptop is 130Mbps/130Mbps. (My phone can get 50Mbps/50Mbps on other WiFi) And have a result:ġ/ My laptop get down/up are 50Mbps/50Mbps (My internet line's only that).Ģ/ My Iphone only get down/up are 30Mbps/30Mbps. Channel 11 (it's the best choice when test with inSSIDer)Īfter that i test with my laptop, my Iphone 5s with SpeedTest Software. I have config my wireless with the option like this: I have a new hAP routers and made a little test with it. I'm a IT staff in a company, and my job's test the new products before my company buy and re-sell them.
0 Comments
Leave a Reply. |